Carrier 30hxc Manual
. COOLER FLUID, VENT, AND DRAIN. BRINE UNITS. PREPARATION FOR YEAR-ROUND OPERATION. 30HXA REFRIGERANT PIPING.
Carrier 30hxc Installation Manual
30HXC CONDENSER CONNECTIONS. INSTALL PRESSURE RELIEF REFRIGERANT VENT PIPING Step 4 — Make Electrical Connections.14.UNIT 30HXC 102.12 45.87 45.87 9.87 (2594) (1165) (1165) (251) 102.12 45.87 45.87 9.87 (2594) (1165) (1165) (251) 102.12 37.63 54.12 9.87 (2594) (956) (1375) (251) 102.12 37.63 54.12 10.47 (2594) (956) (1375) (266) 132.56 72.12 50.63 9.87 (3367) (1832) (1286) (251) 132.56.DIMENSIONS — in. (mm) UNIT 30HXC 72.12 50.63 2.00 (1832) (1286) (51) 61.37 61.37 2.00 (1559) (1559) (51) 61.37 61.37 2.00 (1559) (1559) (51) Fig. 2 — Base Unit Dimensions, 30HXC161-186 Units NOTES: Denotes center of gravity. Dimensions are in inches. Dimensions ( ) are in millimeters. 3.UNIT 30HXA 102.12 45.87 45.87 27.81 9.36 (2594) (1165) (1165) (706) (236) 102.12 45.87 45.87 27.81 9.36 (2594) (1165) (1165) (706) (236) 102.12 37.63 54.12 27.81 9.36 (2594) (956) (1375) (706) (236) 102.12 37.63 54.12 28.41 10.28 (2594) (956) (1375).UNIT 30HXA 72.12 50.63 (1832) (1386) 61.37 61.37 (1559) (1559) 61.37 61.37 (1559) (1559) Fig.
4 — Base Unit Dimensions, 30HXA161-186 Units NOTES: Denotes center of gravity. Dimensions are in inches. Dimensions ( ) are in millimeters. Recommended service clearance around unit (front, back, and one side) is 36 (914).(770) (532) 1890 1346 (857) (610) 1946 1241 (883) (563) 1996 1265 (905) (574) Fig. 5 — Rigging Information 30HXA UNITS — Lb (Kg) MOUNTING PLATE NO. 1326 (252) (360) (190) (420) (601) 1340 (252) (362) (190) (421) (608) 1350.(psig) Maximum Water-Side Pressure (psig) Water Connections (in.) Inlet and Outlet Drain (NPT).Charges listed are for 30HXC units. The 30HXA units are shipped with a holding charge only.
Table 1A — Physical Data, English 5723 5855 6177 6415 4744.Maximum Water-Side 2068 Pressure (kPa) Water Connections (in.) Inlet and Outlet Drain (NPT) ⁄.Charges listed are for 30HXC units. The 30HXA units are shipped with a holding charge only. Table 1B — Physical Data, SI 2596 2656 2802 2910 2933.IMPORTANT: Some of the unit skids are larger than standard door openings. Be sure that the path to the unit’s final destination is wide enough to accommo- date unit shipping skid.
Remove the skid if necessary. If skid is removed and rollers are used, attach rollers to unit tube sheets while moving unit.1. Piping shown is for general point-of-connection only and is not in- tended to show details for a specific installation. Certified field wir- ing and dimensional drawings are available upon request. The 30HXA units should be installed using certified drawings.IMPORTANT: There is a Schrader-type fitting in each of the two MUST BE REMOVED before running the line.
Carrier 30hxc Service Manual
R-22 The 30HXA units are shipped from the factory with a hold- Psig ing charge of R-134a. Before opening the refrigerant sys- 195.9.120 F (48.9 C) saturated condensing temperature, and 105 F (40.6 C) liquid refrigerant temperature.
Size each circuit separately. 10 — R-134a Discharge Line Sizing, 30HXA Units Fig. 11 — Field-Supplied ⁄ -in.
Copper Tube, 30HXA Units.There are 2 relief valves for the cooler; one on each circuit. The 30HXA high side relief valve is provided with a 5/8 in. SAE (Society of Automotive Engineers, U.S.A.) flare connection.
Carrier 30hxc Manual
The 30HXC high side relief valves are provided with a 3/4 in.Table 4A — Unit Electrical Data, 30HXC Units. Advanced apex programming – 4th edition pdf. VOLTAGE Supplied UNIT Nameplate 30HXC (3 Ph) 208/230-60 460-60 575-60 380-60 230-50 346-50 380/415-50 208/230-60 460-60 575-60 380-60 230-50 346-50 380/415-50 208/230-60 460-60 575-60 380-60 230-50 346-50 380/415-50 208/230-60 460-60 575-60 380-60 230-50 346-50 380/415-50.MOCP — Maximum Overcurrent Protection — Rated Load Amps — Wye-Delta Start — Across-the-Line Start.Refer to Carrier’s electronic catalog for the most current electrical data. †Wye-Delta Start is standard. Not available in across-the-line start.